Use DataRest software to retrieve, review, save, print and email therapy data. The docking station attaches to the bottom of the Everest allowing the data card to retrieve therapy tracking information including: start/stop of therapy (including reasons for stopping), start pressure ramp, and interface removal/positioning.

This software kit and module is compatible with all Everest, Everest 2, Everest 3, Aura and Polaris TR CPAP systems. AEIOmed - 500163 and 500164.

Operating times vary depending on your system setup and pressure settings. With the Everest 3 the battery pack will power the unit for an average of 12-hours at 10cm with passover humidification or 8-hours at 10cm with heated humidifier using Enhanced Energy Management settings. With older Everest systems the battery pack will power the system for approximately 11-hours at 10cm with passover humidification. Using heated humidification with older Everest systems will significantly reduce battery life, usually by approximately 50%.

The battery pack can be recharged from any AC (via the Everest power cord) or DC power source (via the Everest Mobile Power Adapter) by itself or while attached to an Everest CPAP. Recharge time averages less than 4 hours with depleted cells. The Battery Pack uses dry cell batteries that are allowed as carry ons by the FAA. Airline security machines (X-Ray, etc) will not damage the Everest CPAP or battery pack. Warranty 1-Year. AEIOmed - Part 1145252.

The Everest heated humidifier provides just enough water for one night’s use, and the reservoir is simple to fill and clean. Heating is controlled easily using buttons built directly into the face CPAP. The humidifier weighs approximately 1 lb and adds 2 inches of height to the Everest CPAP unit when attached. Reservoir Capacity = 240ml. Heat Settings = 0 (off) to 5 (warmest). Maximum Output Humidity = 88%. Safety Temperature Off = 60º C.